Sawstop T-Glide Fence System Instrukcja Użytkownika

SawStop®T-Glide™ Fence System-Industrial SeriesOWNER’S MANUAL

Place a combination square on the table top and against the left face plate. See Fig. 13. Use a 6 mm hex key to adjust the leveling screws as necessar

It is usually possible to adjust the position of the face plates by lightly tapping the top or bottom edge of the face plates with a plastic or wooden

page 109202247196212515222824212352419856171831817131412SawStop 36” Rails and Extension Table 261718273page marker

page 1136 Inch Rails and Extension Table Parts ListNo. Description Part No. Qty.36 inch Rail Assembly (hardware in fence box)* CBFR104 36001 Front Rai

page 1289192520212822242225237181719154246131412SawStop 52” Rails and Extension Table 36317181526171827page marker

page 13No. Description Part No. Qty.52 inch Rail Assembly (hardware in fence box) CBFR104 52001 Front Rail CBFR104 5201 12 M8x35 Countersunk Socket He

page 14SawStop T-Glide™ Fence AssemblySawStop

page 15No. Description Part No. Qty.Fence Assembly (items 1 - 17 assembled)* CBF105 0001 Fence Tube CBF105 001 12 Face Plate CBF105 002 23 M6x1x12 Soc

SawStop, LLC9564 S.W. Tualatin RoadTualatin, Oregon 97062www.sawstop.comMain Phone - (503) 570-3200Service - (503) 582-9934Fax - (503) 570-3303Email:

1. You must install a rip fence before using your saw. Attempting to use the saw without a rip fence could result in serious personal injury.2. Alwa

InstallationTo install the rails, extension table, and fence you will need the following tools:5 mm hex driver and 6 mm hex key (included)13 mm and 17

2. Installing the Rear Rail: You install the rear rail like you installed the front rail, except that you will probably want to leave the rear rail a

Each support leg is mounted to the underside of the extension table using two angled brackets. Align the two holes in the support leg to the two holes

Next, install the M8 x 45 socket head bolt and D-washer through the hole in the center of the left side of the extension table. The bolt should also e

4. Installing the Main Tube: The main tube is installed on the front rail using the M8 x 16 hex head bolts with attached washers. Position the tube o

Once the fence is correctly clamped to the main tube, adjust the position of the left end of the tube so that there is only a small gap (approximately

If there is any misalignment, you can correct it by turning one of the two parallelism adjustment screws in the vertical edge of the fence glide brack